[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] TP's 09-03-08 (1737 KUT info)
Hi Dennis,
I was probably too wordy. To hear KUT with a regular receiver that has SSB 
mode, simply tune to 1737.0 and use USB mode (It's a standard frequency, if 
using 9 kHz tuning steps, too.) To hear KUT in CW mode, tune to 1737.373 and 
use the narrowest CW IF filter you have, and if you have an external narrow 
audio filter, switch it in too. It fades in and out, so usually sitting on 
the freq is needed.
1725 GA, PNG beacon is a normal nominal +/- 1020Hz offset beacon; usually 
the lower sideband is heard better, when GA is heard at all. For a SSB 
radio, tuning to either USB or LSB could be used when tuned to 1725.0; in CW 
mode with a narrow audio filter, I hear it on -1030 and +1010 Hz offsets 
from 1725.000.
Steve
----- Original Message ----- 
From: <vroomski@xxxxxxxxxxx>
To: <irca@xxxxxxxxxxxxxxxx>
Sent: Wednesday, September 03, 2008 11:26 AM
Subject: Re: [IRCA] TP's 09-03-08 (1737 KUT info)
--
Hi Steve,
Thanks for the inforation on KUT.  I will give 1737.373
a try this coming morning on USB and will have
the BWC control on the JRC 545 set to a very
narrow band width.
The tone that I did hear, was not heard latter in the
morning after trying a few times.
Dennis,
Salmon Creek, WA
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the 
original contributors and do not necessarily reflect the opinion of the 
IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx